auto shift problem

is1965 · Post by **is1965** » Fri Nov 11, 2011 9:56 pm

hi

i am having problem were the auto full throttle shifs are nt shifting as per table and is going to rev limiter , can this be caused by the maf sensor causing motor to run lean and knock sensor causing ignition retard

i have a log from tunerpro rt if that helps??

Post by **yoda69** » Sat Nov 12, 2011 5:21 am

What model vehicle & engine?
Can you also post up the bin so we can see what's changed, otherwise really guessing.
Shift points are all based of TPS and Engine RPM, so doubt MAF will have anything to do with it.

yoda69

Post by **Holden202T** » Sat Nov 12, 2011 8:42 am

has the car got different diff gears in it ?

is1965 · Post by **is1965** » Sat Nov 12, 2011 9:15 pm

Yep motor is in a hiace van with different diff ratio
The person that has don the bin has asked me not to give out sorry
Does detent override 100 % throttle shifts speed ??

Post by **VL400** » Sat Nov 12, 2011 10:37 pm

Prob better, and easier, to go back to the guy that done it and have him fix it?

Post by **yoda69** » Sun Nov 13, 2011 6:03 am

Sorry, without being able to look at the bin there's too many possibilities.
Don't know what base bin was used, factory or kalmaker, or what parameters have been changed.
As VL400 said, you'll need to go back to whoever did it for you and get them to fix it.

yoda69

is1965 · Post by **is1965** » Sun Nov 13, 2011 7:29 pm

The person that done the tune is sending me another chip as we think the detent speed setting are overriding the 100% throttle shift table ????

Post by **antus** » Tue Nov 15, 2011 12:18 pm

Sorry, but if you are dealing with someone behind the scenes and dont share the bin or specific details, then we cant help.

auto shift problem

auto shift problem

Re: auto shift problem

Re: auto shift problem

Re: auto shift problem

Re: auto shift problem

Re: auto shift problem

Re: auto shift problem

Re: auto shift problem