Hi guys what info have you got about the level 3 clusters?
As I just put one in my vs and am having a few problems
All the distance and time stuff works but none of the fuel stuff dose
Is there a way to test to see if the pcm is spitting out the info on pin f7?
Dose the manual. Bins still use F7?
Or is there a way to test the cluster to see where my problem is
level 3 dash
- VL400
- Posts: 4991
- Joined: Sun Mar 01, 2009 2:54 pm
- cars: VL Calais and Toyota Landcruiser. Plus some toys :)
- Location: Perth, WA
- Contact:
Re: level 3 dash
VS Ecotec PCM? F7 should be right in that case, can measure it with a multimeter. It is a PWM signal but should see something on it that rises with engine RPM/load.
Re: level 3 dash
Thanks gives me something to start with
Yer vs ecotec and everything looked at pointed to f7
Yer vs ecotec and everything looked at pointed to f7
Re: level 3 dash
Remembered I had the multi in my car
So tested and looks as if the pcm is doing its this
looks like the cluster is coming back out
So tested and looks as if the pcm is doing its this
looks like the cluster is coming back out
Re: level 3 dash
Got it all sorted turned out to be a major
ID-10-T error or idot error
ID-10-T error or idot error