Oxygen Sensor question
- delcowizzid
- Posts: 5493
- Joined: Sat Feb 28, 2009 8:38 pm
- Location: Wellington NZ
- Contact:
Re: Oxygen Sensor question
no 02's and no cats on vn's here hsv spark map too if i remember right
If Its Got Gas Or Ass Count Me In.if it cant be fixed with a hammer you have an electrical problem
Re: Oxygen Sensor question
Im going to be doing some logging on a race car with an 808 and V6 soon.
Any good ideas where to fit the signal earth for my wide band?
Heater ground could go to the battery along with the positive for the heater?
Any good ideas where to fit the signal earth for my wide band?
Heater ground could go to the battery along with the positive for the heater?
- VL400
- Posts: 4991
- Joined: Sun Mar 01, 2009 2:54 pm
- cars: VL Calais and Toyota Landcruiser. Plus some toys :)
- Location: Perth, WA
- Contact:
Re: Oxygen Sensor question
Signal earth to the ECU earth, D6 would be fine for that. Heater earth to battery or chassis somewhere. Could even use one of the other noisy ECU earth connections for the heater.
- Holden202T
- Posts: 10311
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: Oxygen Sensor question
yeah that's what I did with mine on the ecotec 808 loom, heater ground to closest earth, then positive from the coil pack power, and the two sensor wires to the ecm as stated above.
No matter what the question is, the answer is always more horsepower!
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Re: Oxygen Sensor question
Sounds like a good set up, signal wire and signal earth to ecu should get some good readings.
- Holden202T
- Posts: 10311
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: Oxygen Sensor question
yeah I had a wideband in the car for tuning, but I always saw good cross counts when logging it!
No matter what the question is, the answer is always more horsepower!
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Re: Oxygen Sensor question
Off topic, but another question regarding using a VR loom with 808. VR diagram shows the negative of 4 injectors going to C15, with the other 4 going to C16 separately? VN diagram shows the injector negatives joined before the ECU but still going to two different ecu pins. Do I need to join the two negative wires together or is it done internally by the ECU anyway?
Re: Oxygen Sensor question
Does the 808 fire 4 injectors at a time or just pump all 8 at once? My old Vn loom seems to have all injector negatives joined together in the loom.
Re: Oxygen Sensor question
Fires 8 at once.
Re: Oxygen Sensor question
ThanksDylan wrote:Fires 8 at once.