Ref input & ref low are crank & cam signals (needed for engine speed and position by ecu)
EST output = electronic spark timing (the ecu controlls the timing in accordance with engine speed)
Bypass control = sets the timing at base value so as it can be checked/set (diagnostic mode)
Hope that helps.
Altronics high energy ignition kit module
Re: Altronics high energy ignition kit module
Last edited by Gareth on Mon Jan 04, 2016 12:26 pm, edited 1 time in total.
According to chemistry, alcohol is a solution...
Re: Altronics high energy ignition kit module
Hey Dylan I used the orginal - coil wire to trigger the altronics module...you can adjust spark and frequency with this little unit.. only issue I have is when you go to
start the car it will just crank but if you crank it and then stop and crank again it starts.
start the car it will just crank but if you crank it and then stop and crank again it starts.