my ride vt ecotec
Re: my ride vt ecotec
figured it out but the table only goes to 6375rpm will my pump cut out above that? or is there a way to get the table to go above that as my limiter is set to 6500rpm??
The answer is always... boost!
Re: my ride vt ecotec
Maybe try another value like coolant temp or TPS and boost
- VL400
- Posts: 4991
- Joined: Sun Mar 01, 2009 2:54 pm
- cars: VL Calais and Toyota Landcruiser. Plus some toys :)
- Location: Perth, WA
- Contact:
Re: my ride vt ecotec
Bottom of page 6 of the advanced guide has your answer .. viewtopic.php?f=28&t=3051vt3.8lt wrote:figured it out but the table only goes to 6375rpm will my pump cut out above that? or is there a way to get the table to go above that as my limiter is set to 6500rpm??
Re: my ride vt ecotec
ok cool thanks for the reply if im reading this right then as long as its in the kpa range ive selected then the pump will still be on above the limits of the map???
The answer is always... boost!
- Holden202T
- Posts: 10311
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: my ride vt ecotec
outside the limits of the map it uses the last value in the map, so if that's on, it stays on still it come back into the map!
I have mine setup like this for second pump on with boost, I set it to come on over 105kpa and above 3200rpm (I use 2 step rev limiter on 3000rpm)
I have mine setup like this for second pump on with boost, I set it to come on over 105kpa and above 3200rpm (I use 2 step rev limiter on 3000rpm)
No matter what the question is, the answer is always more horsepower!
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread