Delco tuning for for dummys
Re: Delco tuning for for dummys
Oh ok i'll leave it at 89 i left it idling and it cuts on and off fine i think my thermostat is about 70 seemed to get to 70 pretty quick then very rarely over 80 with the clutch fan .
- Holden202T
- Posts: 10311
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: Delco tuning for for dummys
oh, well if you have a cxlutch fan and the thermo you could probably make the thermo setting higher...
No matter what the question is, the answer is always more horsepower!
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Re: Delco tuning for for dummys
I took the clutch fan off and installed the thermo but it isn't efficient enough .
I am now going to fit the twin au thermo fans.
I am now going to fit the twin au thermo fans.
- Holden202T
- Posts: 10311
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: Delco tuning for for dummys
yeah twins should do it, my mates 304 has twins and it works fine in traffic without the mechanical fan
No matter what the question is, the answer is always more horsepower!
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Re: Delco tuning for for dummys
Finally got my pacemakers on and a twin cat into 3 inch can't believe what a difference it has made to the mixtures leaned out as much as 17 on the wideband in some areas.
Got the knock sensor in as well as fitted the filter board on the nvram.
It just never ends i want to buy a new 02 sensor as well any recommendations.
These look ok to me anyone used them before.
1. http://cgi.ebay.com.au/HOLDEN-OXYGEN-SE ... ccessories
Got the knock sensor in as well as fitted the filter board on the nvram.
It just never ends i want to buy a new 02 sensor as well any recommendations.
These look ok to me anyone used them before.
1. http://cgi.ebay.com.au/HOLDEN-OXYGEN-SE ... ccessories
- delcowizzid
- Posts: 5493
- Joined: Sat Feb 28, 2009 8:38 pm
- Location: Wellington NZ
- Contact:
Re: Delco tuning for for dummys
http://cgi.ebay.com.au/OXYGEN-SENSOR-O2 ... ccessories i get all mine through him
If Its Got Gas Or Ass Count Me In.if it cant be fixed with a hammer you have an electrical problem