Ah cheers thanks a lot guys.
The wideband i will need a bit of know how to where i wire it into the ecu. Then by me doing that will it work straight off the bat or will some other changes need to take place for it to work?
$$ or beer in exchange of showing a noob the ropes
- antus
- Site Admin
- Posts: 8253
- Joined: Sat Feb 28, 2009 8:34 pm
- cars: TX Gemini 2L Twincam
TX Gemini SR20 18psi
Datsun 1200 Ute
Subaru Blitzen '06 EZ30 4th gen, 3.0R Spec B - Contact:
Re: $$ or beer in exchange of showing a noob the ropes
The default settings are right for most widebands. If its out adjust the wideband 0 and 5 volt settings to match the specs for your hardware. The signal pin is documented with the other pins in the 12p download zip. You'll probably need to move the stub of an unused pin like ac request in the loom plug as the wideband pin isnt used in factory calobration and its not usually populated.
Have you read the FAQ? For lots of information and links to significant threads see here: http://pcmhacking.net/forums/viewtopic.php?f=7&t=1396