Vt getrag speedometer
Re: Vt getrag speedometer
There is no loom for it so I'm trying to get it going by itself to fit it to my dash in the vk
Re: Vt getrag speedometer
You might need to flash a VS3 calibration to get the speedo output working from the ECU
- antus
- Site Admin
- Posts: 8250
- Joined: Sat Feb 28, 2009 8:34 pm
- cars: TX Gemini 2L Twincam
TX Gemini SR20 18psi
Datsun 1200 Ute
Subaru Blitzen '06 EZ30 4th gen, 3.0R Spec B - Contact:
Re: Vt getrag speedometer
Dunno about the tune but its an 11p capable 424 maybe with 11p and the auto dtcs masked.
Have you read the FAQ? For lots of information and links to significant threads see here: http://pcmhacking.net/forums/viewtopic.php?f=7&t=1396
Re: Vt getrag speedometer
Yea no idea what that means, I might have to do some learning before I can figure this one out haha
Re: Vt getrag speedometer
The car runs great though and doesn't have any running issues ,basically it's a vk with a vt block and getrag290 with 98 vs v8 auto ute used as the donor for all the loom and gear etc
Re: Vt getrag speedometer
Get a Dakota Digital SGI5E. Convert the signal type and the pups count all in one.
Re: Vt getrag speedometer
I'll look at that thanks
-
- Posts: 159
- Joined: Mon May 22, 2017 1:55 am
- cars: vp 'moo mang' ute
torana
bombadores - Location: Sydney
Re: Vt getrag speedometer
Had vs s3 manual in lc torrie...not looked in awhile vaguely remember manual harness & ecu different to auto also read somewhere here that signal of speedo sensor is different.
When first got mine running couldn't fit speedo sensor in torrie tunnel so would intermittently pop up that fault code...rare occasions stalled when stopping at slow speeds.Never happened with sensor fitted after tunnel was clearanced.
Can't recall if it was a vs v8 diagram thread or conversion forum.
So I'd say something like signal convertor as Dylan suggested & memcal modded to suit manual.
When first got mine running couldn't fit speedo sensor in torrie tunnel so would intermittently pop up that fault code...rare occasions stalled when stopping at slow speeds.Never happened with sensor fitted after tunnel was clearanced.
Can't recall if it was a vs v8 diagram thread or conversion forum.
So I'd say something like signal convertor as Dylan suggested & memcal modded to suit manual.