Page 2 of 3
Re: BCM Simulator
Posted: Sat May 21, 2011 6:09 pm
by jacomms
Very Nice!!!!
Re: BCM Simulator
Posted: Sat May 21, 2011 8:40 pm
by The1
awesome!
Re: BCM Simulator
Posted: Sun May 22, 2011 8:46 am
by Holden202T
happy days!
Re: BCM Simulator
Posted: Mon Aug 22, 2011 6:54 am
by holden08
is there a way you could get one of these connected to a 808 ecu to control a vy dash
Re: BCM Simulator
Posted: Mon Aug 22, 2011 8:18 am
by VL400
With lots of code changes to the 808 it might be possible to get working, never really looked at it though as the market would be very small and 12P has no RAM left so it cant happen on that.
Re: BCM Simulator
Posted: Sun Jul 15, 2012 7:14 pm
by Fireblade.954
Hi, how much are you doing these for assembled? Also could I use it to simulate bcm on a stock ecotec, conversion? ,
Thanx.
Re: BCM Simulator
Posted: Sun Jul 15, 2012 9:45 pm
by VL400
Will send you a PM with more details, but yes it will allow you to run a ecotec in a conversion without disabling the anti-theft and also retain the low speed fan and other engine related functions normally handled by the BCM.
Re: BCM Simulator
Posted: Sun Jul 15, 2012 10:41 pm
by kham383
Can you send me some details also. Will it work with a ls1 pcm & vy dash cluster.thanks Ron.
Re: BCM Simulator
Posted: Sun Jul 15, 2012 10:52 pm
by VL400
I have only just got a PIM for testing with a LSx PCM so at this stage I would say no it does not support the LS1 sorry. It also wont work without a PIM either as this simulator is only ALDL.
Re: BCM Simulator
Posted: Mon Jul 16, 2012 7:47 pm
by kham383
I was under the impression the pcm talks vpw to the pim then aldl from pim to bcm & dash?
If not what is the chain of communication protocols.thanks.