Need some advice 1965 XP falcon 250 turbo

[Holden202T]

my comment is still the same, other than your picture i haven't seen anything else.

[festy]

Threaded injector bungs aren't too common, but 11mm versions just don't seem to exist.
You could use the 14mm ones you found, along with 11-14mm nose adapters?
If you really need screw in bungs, you might have to make them yourself - but I'd recommend welding bungs in if it's at all possible.

[gravelrash]

progress so far. standard falcon injectors are in there just for the initial build up.

[gravelrash]

im needing some help right now, i am a little lost as to where the coil negative wire goes to. its a brown wire i have obviously cut it out while i was shortening up the harness to fit the falcon. hope you guys can help.
apart from that everything is coming along fine with the conversion.

[VL400]

It will go to the ignition module, if its a camira its the inner connection of the two pin connector. Pinouts are here http://ishop2.cooldrive.com.au/products/IM118

[gravelrash]

yeah sorry i know about the module to coil wires, the one that tricking me up is the other 2 wires on the coil. in particular the brown wire.

[VL400]

Tacho maybe?

[gravelrash]

Tacho maybe?

i was thinking that, can i still use the tacho feed from the MSD or do i have to use that one? thanks for your help VL400

[Holden202T]

is this what your after ?

http://www.oldholdens.com/temp/carstuff ... le0005.pdf

[gravelrash]

thats it, thanks fellas. i will post up some more progress pics shortly. thanks for the help