Page 2 of 2
Re: .bin ID
Posted: Mon Oct 08, 2012 11:39 am
by antus
you can post anything, but the binary image of the chip. xdfs, lists of addresses, locations of gaps and changes, ok.
Re: .bin ID
Posted: Mon Oct 08, 2012 5:31 pm
by muttley383
Sorry for any wrong doing.
I received the memcal from a friend and was curious if I properly read the .bin.
Thanks for the help and assistance.
Re: .bin ID
Posted: Mon Oct 08, 2012 5:53 pm
by VX L67 Getrag
Well to answer that, yes I believe it was read correct, to get it to line up with VR HSV Auto BKBK I had to modify around 10 various sections!
I'm in the middle of trying to modify the bins to get them to line up with $12 as I think it's the closest that has an XDF made for it as there is no $3C XDF!
Re: .bin ID
Posted: Tue Oct 09, 2012 6:17 pm
by VX L67 Getrag
As promised I wasted WAY too much time today altering the layout of stock BKBK $3C to line up as close as possible (not all exact but close)with $12 XDF that’s already been made & this is what I did & need to do it in the order from top to bottom in Word Doc!
By The way mutley do you know if it was auto or manual?
Re: .bin ID
Posted: Wed Oct 10, 2012 7:38 am
by muttley383
From what I was told it was for a VN GrpA. So I assume that it would be for a manual transmission.