11p ecotec turbo tune

vt3.8lt · Post by **vt3.8lt** » Thu Oct 30, 2014 5:55 pm

hey guys this should be the bin im using

its not perfect but has gotten allot better cheers dane

OSE_11P V102 CAKH V6 __rescale.BIN: (64 KiB) Downloaded 511 times

Post by **VL400** » Fri Oct 31, 2014 12:21 pm

Attached is your bin migrated to v104.

To write it use the current flashtool v1.50, set the preferences up to use your com port and "VR V6/V8", connect to the PCM, choose write bin, select this bin and wait around 2 minutes.

Make sure you then use the v104 ADX and XDF when tuning.

vt3.8lt · Post by **vt3.8lt** » Sat Nov 01, 2014 7:31 pm

cool thanks man can i use tp5 to upload this or should i use the flashtool just havent had the flash tool work yet cheers again

Post by **VL400** » Sat Nov 01, 2014 7:37 pm

You have to use the flashtool as its writing the entire bin rather than just the cal area.

vt3.8lt · Post by **vt3.8lt** » Wed Nov 19, 2014 7:24 pm

Hey guys had the commy dynoed today it made 203rwkw (276rwhp) at the 9psi it's running I'm quite happy with it and the way it's running I haven't changed it to that merged bin yet cause I wanted to get the dyno out of the way and been just to busy but I will get onto it as soon as I get a spare chance gonna also put a water meth injection kit on it just for the safety benefits cheers dane

vt3.8lt · Post by **vt3.8lt** » Wed Nov 19, 2014 7:25 pm

: DSC_0021.JPG (1.27 MiB) Viewed 7188 times

Post by **Holden202T** » Thu Nov 20, 2014 8:33 am

nice result for the boost your running, and its going fairly rich in the upper revs so theres probably more to be had there too!

vt3.8lt · Post by **vt3.8lt** » Thu Nov 20, 2014 10:28 am

Thanks man yeah thats what he said ill probably pick up a few kw if i bring the fuel back but im happy with the results keen to get this water meth on it and see if i can get a bit more out of it aswell

Post by **Holden202T** » Thu Nov 20, 2014 11:15 am

what kit are you using for the water/meth ? my brother has just purchased one from VPW, it looks pretty decent, but we haven't started the install yet just looked at the bits in the box!

vt3.8lt · Post by **vt3.8lt** » Thu Nov 20, 2014 11:36 am

i was gonna go with a aem kit but they are pretty pricy im thinking about a diy job possibly using a spare i/o from the vr ecu if there is ont to activate it not sure yet might just get the aem kit yet depends what my budget allows id be keen to see how your brothers kit goes sounds like a decent product

11p ecotec turbo tune

Re: 11p ecotec turbo tune

Re: 11p ecotec turbo tune

Re: 11p ecotec turbo tune

Re: 11p ecotec turbo tune

Re: 11p ecotec turbo tune

Re: 11p ecotec turbo tune

Re: 11p ecotec turbo tune

Re: 11p ecotec turbo tune

Re: 11p ecotec turbo tune

Re: 11p ecotec turbo tune