pcmhacking.net

hey guys this should be the bin im using its not perfect but has gotten allot better cheers dane

Attached is your bin migrated to v104.

To write it use the current flashtool v1.50, set the preferences up to use your com port and "VR V6/V8", connect to the PCM, choose write bin, select this bin and wait around 2 minutes.

Make sure you then use the v104 ADX and XDF when tuning.

cool thanks man can i use tp5 to upload this or should i use the flashtool just havent had the flash tool work yet cheers again

You have to use the flashtool as its writing the entire bin rather than just the cal area.

Hey guys had the commy dynoed today it made 203rwkw (276rwhp) at the 9psi it's running I'm quite happy with it and the way it's running I haven't changed it to that merged bin yet cause I wanted to get the dyno out of the way and been just to busy but I will get onto it as soon as I get a spare chance gonna also put a water meth injection kit on it just for the safety benefits cheers dane

nice result for the boost your running, and its going fairly rich in the upper revs so theres probably more to be had there too!

Thanks man yeah thats what he said ill probably pick up a few kw if i bring the fuel back but im happy with the results keen to get this water meth on it and see if i can get a bit more out of it aswell

what kit are you using for the water/meth ? my brother has just purchased one from VPW, it looks pretty decent, but we haven't started the install yet just looked at the bits in the box!

i was gonna go with a aem kit but they are pretty pricy im thinking about a diy job possibly using a spare i/o from the vr ecu if there is ont to activate it not sure yet might just get the aem kit yet depends what my budget allows id be keen to see how your brothers kit goes sounds like a decent product