pcmhacking.net

Posted: **Thu Oct 06, 2016 6:42 pm**

Thanks for the info doctortuned, very interesting site as well. I am looking into your suggestion.

Posted: **Thu Oct 06, 2016 6:44 pm**

Thanks for the information doctortuned, I am going to look into it

Posted: **Thu Feb 09, 2017 12:08 pm**

Did you end up making any progress on this? I've got an LQ9 for my '68 and seem to be in the same boat as you.

Posted: **Sun Feb 12, 2017 10:35 am**

doctortuned wrote:I don't use it but I have seen it. Tunerpro.net is a free software and there is a free definitions on gearheadefi page for it. The xdf files are separated such as one will be for timing then another for fuel. it's a little more complicated. But if your looking for free. This is if you are using the ls1a pcm. If you can read the binary and email it to doctortuned@yahoo.com I'll help you with it.

To the best of my knowledge Tunerpro only works for obd1 cars and not obd2. The OP should look into lt1edit or carputing.com.

edit: Apparently I'm wrong.

http://www.gearhead-efi.com/Fuel-Inject ... CM-Project!

pcmhacking.net

gm ecu programming

Re: gm ecu programming

Re: gm ecu programming

Re: gm ecu programming

Re: gm ecu programming