Page 2 of 2
Re: TunerPro Probs.
Posted: Sun Sep 05, 2010 1:55 pm
by v6bucket
I've restarted TP5 whilst it's connected to the ecm, "Hardware Not Found" shows up down the bottom. I done this several times.
Re: TunerPro Probs.
Posted: Sun Sep 05, 2010 4:43 pm
by VL400
Does the flashtool work to do a 'get bin'? Follow instructions here if you need the setup, basically just select the com port and tick ignore echo ...
https://pcmhacking.net/forums/viewtopic.php?f=3&t=82
What are the LEDs on the comms board doing when your trying to connect?
Re: TunerPro Probs.
Posted: Mon Sep 06, 2010 12:15 pm
by v6bucket
VL400, sorry for the delay in responding, this is what I've found.
When trying to connect TP5 (ign on)USB PWR=blue led on
TX led =red led flashes while trying to connect, then goes out (when no hardware shows up)
RX led = nothing
Install Flash Tool V1.27, Press Connect to ECM, same as above accept TX led flashes faster. Attached is the detailed info. Hope this is of some use.
Re: TunerPro Probs.
Posted: Mon Sep 06, 2010 12:45 pm
by Holden202T
is the ignore echo tick box wrong ? should be unticked in the preferences ?
Re: TunerPro Probs.
Posted: Mon Sep 06, 2010 12:48 pm
by VL400
Have PM'd you some things to try in regard to the USB board - its not TP related so will keep it separate from this thread.
USB interface must have the ignore echo tick box checked, which the log says you have done.