Tester Engineering Suite v1.0.9-2026 Released

[jakka]

I've been working on development non stop since this post and have further implemented features to bring the software in line as a competitor with Aftermarket scantools. It has a fully implemented Dual Protocol, Local and Remote CAN & K-Line Diagnostic Stack now - so that means vehicle compatibility back to 1996! It covers the pre-CAN legacy diagnostics as well as the hybrid era 2000's and the post 2008 mandate for CAN in vehicles, with dozens of protocols implemented in the software.

message me if you want more information

[jakka]

signal-2026-04-23-22-54-26-001.jpg

[jakka]

https://tester.engineering

[jakka]

signal-2026-05-19-16-48-00-261.jpg

[KingAustraliaggGG]

[jakka]

Progress is booming - I am up to v1.0.7-2026

[jakka]

Full A2l and XDF definition binary file editor - a calibration suite as well as diagnostics, programming, CAN investigation, and almost a hundred thousand OEM diagnostic procedures - so this tool is now in a position to compete directly with aftermarket scan tools and I am definitely going to start pissing off the big boys by offering something with far more capability for 10% of the cost of their solutions. Tuners, Mechanics, Reverse Engineers, Actual Engineers - this is the motherfucking tool for you.

[jakka]

@Antus

[jakka]

Hey bro

[jakka]

Some of the advertisements for Social Media....