Page 11 of 16
Re: Delco DIS On Non DIS Engine
Posted: Thu Jun 20, 2013 10:58 pm
by antus
what wiring diagram are you using? the wiring info in the 12p thread is correct.
https://pcmhacking.net/forums/view ... f=27&t=356
Re: Delco DIS On Non DIS Engine
Posted: Thu Jun 20, 2013 11:02 pm
by Chubs0191
out of a Haynes manual for vn I knew I had seen it somewere thanks
Re: Delco DIS On Non DIS Engine
Posted: Fri Jun 21, 2013 8:49 am
by antus
It should be correct, but if you doubt it grab the camira or pulsar wiring diagrams from the 12p thread linked above. Depending on what loom you have some of the wiring colours might be different, but the power ones will not be so if they dont match then you need to dig deeper.
Re: Delco DIS On Non DIS Engine
Posted: Fri Jun 21, 2013 10:34 am
by Chubs0191
Yeah the colours don't worry me just the pinouts don't match across not references I'll just use the 12p info can some one please verify if this is a "yank" module
Re: Delco DIS On Non DIS Engine
Posted: Fri Jun 21, 2013 11:29 am
by antus
Yeah, thats the right module. If you need a 6 pin connector send me a PM. I have a few left over from when I imported a batch.
Re: Delco DIS On Non DIS Engine
Posted: Fri Jun 21, 2013 3:24 pm
by kojab
antus if you can spare another 6 pin connector please send me a PM and I will send you some money and my address.
Cheers
Dick
Re: Delco DIS On Non DIS Engine
Posted: Fri Jun 21, 2013 6:54 pm
by Chubs0191
Sent you a pm antus
Re: Delco DIS On Non DIS Enigine
Posted: Thu Jun 27, 2013 5:45 pm
by Chubs0191
antus wrote: The 3 pin one can be found on the ecotech knock sensor on the front of the engine.
the commodore wrecker tells me that the plug for an ecotec knock sensor is the same as every other knock sensor???
Re: Delco DIS On Non DIS Engine
Posted: Thu Jun 27, 2013 6:11 pm
by Holden202T
that's correct!
Re: Delco DIS On Non DIS Engine
Posted: Thu Jun 27, 2013 6:14 pm
by charlay86
ecotec knock sensor is a single pin connector, not a 3 pin. I suspect antus meant a different connector