pcmhacking.net

lets move to NZ ?

delcowizzid wrote:oh myyyyy 10psi on the brakes full throttle at 3000rpm we normally at 3000rpm no boost part throttle due to too much torque to get positive psi boost launches gonna be crazy staging might be a little harder but hoping some tuning should get it on faster
[youtube]https://www.youtube.com/watch?v=r4PcZtHao3k[/youtube]

I think your car is twisting in half lol

If there's no European wasps there it will be better for tuning vlad, no cops either by the look of it !

sure would, so sick of getting hit in the face with wasps already.

vlad01 wrote:

delcowizzid wrote:oh myyyyy 10psi on the brakes full throttle at 3000rpm we normally at 3000rpm no boost part throttle due to too much torque to get positive psi boost launches gonna be crazy staging might be a little harder but hoping some tuning should get it on faster
[youtube]https://www.youtube.com/watch?v=r4PcZtHao3k[/youtube]

I think your car is twisting in half lol

haha it actually is physically tearing in half .it creases the rear 1/4's when it launches and keeps tearing the seam in the passenger door shut plus the c pillars move that far that the old green shows through where the window rubber shifts at least 10mm and uncovers the old paint.shes getting awefully soft hence this season its getting full weld in cage and other mods LOL

lol I thought that was the case. Torque FTW!

fitted a speed hole today LOL shame to cut a perfectly good bonnet just for one meeting but oh well LOL

but speed holes make it go faster. Especially ones with turbos inside the hole.

bit of GM flat black she be like new again

better to cut the bonnet than cut the top off the turbo