Page 14 of 16
Re: ALDL ECU's
Posted: Thu May 21, 2015 7:02 pm
by Dylan
Coulld this update help with reading the engine data?
Re: ALDL ECU's
Posted: Thu May 21, 2015 7:12 pm
by Tazzi
Dylan wrote:Coulld this update help with reading the engine data?
Yep, I fixed that just before! I had a little mistake which missed out on the VS S3 V8's!
Just sorting out this graphing stuff first then Ill upload the newest version.
Re: ALDL ECU's
Posted: Thu May 21, 2015 7:26 pm
by Dylan
Cool can't wait to test it
Re: ALDL ECU's
Posted: Thu May 21, 2015 8:28 pm
by Tazzi
There we go. All fixed!
- NewGraphing.PNG (28.74 KiB) Viewed 7434 times
Re: ALDL ECU's
Posted: Thu May 21, 2015 8:49 pm
by Tazzi
v0.0.0.4 Now available!
Changes include:
- adding 2more parameters to the graph.
- Fixed issue with VS S3 V8 (Engine data read and fault data)
- Error catches
- Reading is on separate thread to processing
Re: ALDL ECU's
Posted: Fri May 22, 2015 10:11 am
by Tazzi
The only thing left to do now, is add a little checkbox for "disable chatter" for the engine data reads. Hopefully thatll give a massive boost to the frames/s when needed.
And also an option to only record engine or transmission information
I dont mind it being a bit slower while cruising around, but be good to have the option available.
Re: ALDL ECU's
Posted: Fri May 22, 2015 8:41 pm
by Dylan
Is it possible for the ALDL based ECU's to be put into diagnostic mode electronically?
Would be great feature on some software to have a button to do that.
Re: ALDL ECU's
Posted: Fri May 22, 2015 11:06 pm
by VL400
Cant request diagnostic mode using the mode 4 commands (mode 4 tells the ECU to do certain things), but if its to set the timing you can use mode 4 to command any timing value you want - so can set a value that matches with a notch on the timing cover and set the timing to line up.
Re: ALDL ECU's
Posted: Sat May 23, 2015 7:52 pm
by Tazzi
Not sure Im following on that?
Three new buttons will be add:
1- Disable vehicle comms to enhance frame/s (This is what Tunerpro does).
2- Log only Engine data
3- Log on Transmission data
I just got to add in some checks to the display updates and replay updates to check whether there is any data for trans/engine to process for each gauge.
Also finally. Iv had 1 report that the latest graphing causes a little error to occur after logging for a while and trying to "hover" over the points when "rolling data" has not been ticked. Iv actually recreated this error and I can semi repair this.
From now on, data points cannot be checked by hovering over unless logging has stopped, or the replay data has been paused/stopped.
Oh, and the entire window can now be expanded! I find this good for the graphing as it makes it large to check out!
New version out soon!
Re: ALDL ECU's
Posted: Sat May 23, 2015 8:14 pm
by yoda69
Nice work, had my first play tonight on my VY and looks good.
