Page 19 of 123

Re: My Delcoed Rides

Posted: Thu Apr 28, 2011 9:39 am
by delcowizzid
trap speed ???

Re: My Delcoed Rides

Posted: Thu Apr 28, 2011 11:45 am
by Holden202T
lol yeah im not sure what the deal was there, was a bit pumped thats for sure :D

trap speed was 148kms i think

Re: My Delcoed Rides

Posted: Thu Apr 28, 2011 1:33 pm
by v6bucket
Well done :thumbup: :thumbup:
What fuel were you using?

Re: My Delcoed Rides

Posted: Thu Apr 28, 2011 2:26 pm
by Holden202T
methanol

Re: My Delcoed Rides

Posted: Thu Apr 28, 2011 11:36 pm
by Holden202T
just for delcowizzid!
Time%20Slips.jpg
Time%20Slips.jpg (139.09 KiB) Viewed 4425 times

Re: My Delcoed Rides

Posted: Fri Apr 29, 2011 8:10 am
by v6bucket
Do you have any logs of the passes that you can share?

Re: My Delcoed Rides

Posted: Fri Apr 29, 2011 11:24 am
by Holden202T
unfortunately i don't have a speedo trace in the logs (working on it), but you can see in the log where i did the burnout at 1:16 into log then the pass is at 1:47

please note this adx is intended for VL400's data logger so it may or may not work in a normal logging setup, but it will allow viewing of this log.
12P80800.XDL
(221.85 KiB) Downloaded 292 times
12P808ME.adx
(69.76 KiB) Downloaded 277 times

Re: My Delcoed Rides

Posted: Sat Apr 30, 2011 7:50 am
by v6bucket
What are your cam specs?
Looks like everything shows up in the logs ok, as far as I can tell.

Re: My Delcoed Rides

Posted: Sat Apr 30, 2011 8:28 am
by Holden202T
its a wee little baby cam :D
cam1.jpg
cam1.jpg (67 KiB) Viewed 4425 times
i'm planning some upgrades in a few months, one of them is a bigger converter and a bit bigger cam that will pull harder in the top end!

Re: My Delcoed Rides

Posted: Sun May 15, 2011 7:53 pm
by Holden202T
well with the summerland drags looming (21st) and a torque converter failure in the power glide i have been left with no option but to put a trimatic in the gemini.....

be interesting to see how it stands up to the 202 power and punishment its going to get hehehehe

put a DIY shift kit in it and a heap of new gaskets etc so fingers crossed it works flawlessly!