pcmhacking.net

as in full on wear ??

bit of iron there, strange the comments said 1.4% water detected, but shows <0.1 on the sheet.

yeah that cam was fairly worn when I pulled the motor apart hehehe plus methanol likes to rust bores so probably some iron from that too

Did you get your oil test results?

got mine this morning. not bad at all.

http://www.roktex.com.au/sharedReport?published=528804

nar i still have a heap of km to go yet, nice looking sheet they have there, can you pull out a standard pdf or stats report though?

I only could print the report to PDF file, but there wasn't a downloadable PDF on my report.

hit 300k last week, new oil and filter going in then do the oil test in 5k

Nice ride The1.

Mate I hope mines still kicking at 300k haha, nice work.

right well just did 310,000km oil change, took a sample to send to Roktex, though had to do it from the oil coming out the bolt hole as the pipe didn't go down the dipstick hole and i didn't have anything smaller.

Well no explaining needed, 10,000km the filter works, inside of the tube is clean and no oil as expected being so sticky.