Flash PCM's Made realtime
-
Muncie
- Posts: 231
- Joined: Wed Dec 02, 2020 6:15 am
- cars: Vy commodore, Turbo Ecotec v6
- Location: New Zealand Waikato
Re: Flash PCM's Made realtime
Header in place
You do not have the required permissions to view the files attached to this post.
-
Muncie
- Posts: 231
- Joined: Wed Dec 02, 2020 6:15 am
- cars: Vy commodore, Turbo Ecotec v6
- Location: New Zealand Waikato
Re: Flash PCM's Made realtime
Here's the version with the carrier board
You do not have the required permissions to view the files attached to this post.
-
KingAustraliaggGG
- Posts: 49
- Joined: Fri Nov 15, 2024 2:19 pm
- cars: 323i 1999 e46 sedan m52tub25 ms42 hx35w
328ci 1999 e46 coupe m52tub28 ms42
vy 2002 holden wagon executive l67 bottom end/36 top swap corn fed boost manifold ex44 external turbo hx40 holset
vs holden sedan turbo gt3582r
Re: Flash PCM's Made realtime
Is that like a Pico, Honda ecu repair on Facebook and then I think cobra rtp said that could work in Ecotec and buicks memcal ECUs.
-
Muncie
- Posts: 231
- Joined: Wed Dec 02, 2020 6:15 am
- cars: Vy commodore, Turbo Ecotec v6
- Location: New Zealand Waikato
Re: Flash PCM's Made realtime
2nd one put together today refined process a bit they are now socketed to j4 this makes soldering the 4 needed wires to the u11 plcc32 pad so much easier.......
I also fucked this up today had a wrecker spec pcm that i just went mad at soldered everything in pushed the onerom into header plugged it in. It talked to Tunerpro etc in car crank but no start fuel pump primed etc, Shit!
Plugged it back into the bench connected to OSE flashtool and it still had a vin number fuck my life back out with emulator back in with flash chip wake it up write stock 060a enhanced check vin, gone.
Out with flash chip back in with wires and Onerom carrier finally success.
If you do this overwrite the stock file first with an enhanced version before you go pulling out hardware.
I also fucked this up today had a wrecker spec pcm that i just went mad at soldered everything in pushed the onerom into header plugged it in. It talked to Tunerpro etc in car crank but no start fuel pump primed etc, Shit!
Plugged it back into the bench connected to OSE flashtool and it still had a vin number fuck my life back out with emulator back in with flash chip wake it up write stock 060a enhanced check vin, gone.
Out with flash chip back in with wires and Onerom carrier finally success.
If you do this overwrite the stock file first with an enhanced version before you go pulling out hardware.