pcmhacking.net

not sure but this is the vn v8 tune.

so what are you trying to do, transfer that tune to a vr v8 one so you can use the faster logging ?

i havent yet but i have the coms board for the 808 for faster baud rate so
i need to run a vr v8 manual tune.ive been comparing maps etc though
just to look,im pretty new to this atm still.

well probably your best option is to transfer it into the $12P V110 as stated earlier .... but the issue i see is you really need to know what that was based on, ie. baam etc so you can get a stock bin and compare it to your modified one to see whats been changed, then you can transfer it over from there into $12P

will do that,got another question i bought another ecu as spare
came from a n13 1.8 pulsar can i use the 4cyl memcal?
i noticed the one in my vn v8 atm has a resistor soldered acrosss from
1 pin to another.wondering if i need to do the same with the 4cyl memcal?
i want to put the moates 28 pin socket in and use it for a plug
in for the moastes ostrich only,

Having done a bin compare with a few bins the closest match I got was with ATJN which is a $5D based bin, there were 455 differences.
A copy of ATJN and the $5D XDF can be found here https://pcmhacking.net/forums/view ... hp?f=7&t=3
Hope this helps,
yoda69

2inil8 wrote:will do that,got another question i bought another ecu as spare
came from a n13 1.8 pulsar can i use the 4cyl memcal?
i noticed the one in my vn v8 atm has a resistor soldered acrosss from
1 pin to another.wondering if i need to do the same with the 4cyl memcal?
i want to put the moates 28 pin socket in and use it for a plug
in for the moastes ostrich only,

Sure can .. https://pcmhacking.net/forums/viewtopi ... lit=netres

If you have any chip reading stuff available i'd be cool if you could read that n13 bin for us first. I dont think we have any pulsar bins in the archive yet.

i do have a reader/burner ill load the file on here

thanks!