Re: PCM Hammer Release 014
Posted: Fri Jan 29, 2021 7:02 pm
Add the checksum is not a good solution, most interfaces validate and hide that byte, but even 1 like the AVT is a problem. #1 is an option.
A PR is up.
pcmhacking.net
Electronic Fuel Injection - Developement & Tuning
https://pcmhacking.net/forums/
PCM Hammer Release 014
Page 23 of 23
Re: PCM Hammer Release 014
Posted: Fri Jan 29, 2021 8:22 pm
Valid point ... That is not the reason I had #1 as #1, but I did have #1 as #1 for a reason ...
A PR is up.
A PR is up.
Re: PCM Hammer Release 014
Posted: Sat Jan 30, 2021 10:44 pm
What the flip does MEC stand for ??antus wrote:But I think we need to look at the response in a recovery flash or when MEC > 0, as I think that piece of code is designed for that scenario.
Searching doesn't get it answered!
Thanks!
Re: PCM Hammer Release 014
Posted: Sun Jan 31, 2021 4:28 am
Man you guys have been busy, ive finally got walls and ceilings again so ive got some forward movement too.
Re: PCM Hammer Release 014
Posted: Sun Jan 31, 2021 8:11 am
Awesome, good to hear ...Vampyre wrote:ive finally got walls and ceilings again so ive got some forward movement too.
Re: PCM Hammer Release 014
Posted: Sun Jan 31, 2021 2:45 pm
Re: PCM Hammer Release 014
Posted: Mon Feb 01, 2021 4:26 pm
MEC = Manufacture Enable CounterGampy wrote:What the flip does MEC stand for ??antus wrote:But I think we need to look at the response in a recovery flash or when MEC > 0, as I think that piece of code is designed for that scenario.
Searching doesn't get it answered!
Thanks!
Basically production line mode of key cycles
Re: PCM Hammer Release 014
Posted: Tue Feb 02, 2021 12:29 am
Thank you.