Page 24 of 33
Re: Programmable Delco Ignition Module
Posted: Sat Nov 12, 2016 10:06 am
by Wade
thank you
Re: Programmable Delco Ignition Module
Posted: Sat Nov 12, 2016 12:29 pm
by immortality
VL400 wrote:Wire it up something like this....
VL400_Ign_VT_Dizzy.png
Awesome work VL.
I was wondering if it may be better to wire the 8x coil +ve directly to the battery via a new relay switched using the original coil +ve? as the total power requirement of the 8 coils will be more than the original system was designed to cope with?
Re: Programmable Delco Ignition Module
Posted: Sat Nov 12, 2016 12:41 pm
by Dylan
I've seen that done before.
Re: Programmable Delco Ignition Module
Posted: Sat Nov 12, 2016 7:16 pm
by VL400
That is recommended to do once up and running. The standard config of wade's module does not overlap dwell so the current requirement is only slightly more than standard with LS1 coils. Once the option flag is set for dwell to overlap then the power feed to the coils ideally should be upgraded.
Re: Programmable Delco Ignition Module
Posted: Sun Nov 13, 2016 6:41 pm
by Wade
There gunna look right at home on the ol 5 litre
Re: Programmable Delco Ignition Module
Posted: Sun Nov 13, 2016 7:39 pm
by HQ355
Nice work !
Re: Programmable Delco Ignition Module
Posted: Wed Nov 16, 2016 6:21 pm
by VL400
Lookin good!
Re: Programmable Delco Ignition Module
Posted: Sun Dec 11, 2016 5:56 pm
by Wade
Ok. I'm making a start on installing the module. Although the leads won't be here till after Xmas, so I'm just going to do what I can for now without making the car un-driveable.
Re: Programmable Delco Ignition Module
Posted: Sun Dec 11, 2016 6:00 pm
by Wade
Will it be ok to run the coil grounds to the back of the block and ground them at the same location that the pcm wiring loom ground is? Also with the coil v+ will a 40a relay do? And as for the wiring I've got 25a wire.
Re: Programmable Delco Ignition Module
Posted: Sun Dec 11, 2016 6:02 pm
by Wade
Most resent pics as it sits now