Page 26 of 71
Re: How to loose 200kgs?....
Posted: Tue Nov 03, 2015 7:28 pm
by Gareth
Progress, I don't normally gloat but that rear firewall panel is fucking awsome
And all the driver controls are done, I'm not sold on the brake pedal position, I might move the clutch to the top of the trans tunnel to give more room for the brakes
Re: How to loose 200kgs?....
Posted: Tue Nov 03, 2015 7:33 pm
by Dylan
How'd the electric power steering come up?
Re: How to loose 200kgs?....
Posted: Tue Nov 03, 2015 7:37 pm
by Gareth
Haven't wired it up yet, mechanically it's done, I'm going to add a firewall bracket for good measure (needs a grommet anyway)
Re: How to loose 200kgs?....
Posted: Tue Nov 03, 2015 7:57 pm
by HQ355
Looks great mate, where and when us next race ? May have to have a look !
Re: How to loose 200kgs?....
Posted: Tue Nov 03, 2015 8:19 pm
by Holden202T
yeah your right the back seat panel is the business
shes certainly getting close to being back together!
Re: How to loose 200kgs?....
Posted: Tue Nov 03, 2015 8:46 pm
by Gareth
The goal is to have this ready for the boxing day bash at Daylesford
Re: How to loose 200kgs?....
Posted: Mon Nov 16, 2015 8:13 pm
by Gareth
These turned up in the mail today from The1, should add that they come really well packaged and the injectors where numbered ready to go, very happy with these
So i pulled those blue ones out,
And found fuel dripping out of this...
That is the vac line for the pressure reg... Explains a lot...
Changed to a VS style rail so as to be able to weld in the dash fitting, i assumed the injector retainer clips where the same, they are not...
Re: How to loose 200kgs?....
Posted: Mon Nov 16, 2015 10:16 pm
by vlad01
VN-VR clips should fit.
Those VS regs are 3 bar btw, the VT on are 3.5 bar.
Re: How to loose 200kgs?....
Posted: Mon Nov 16, 2015 10:30 pm
by The1
Be good to see results and how the injectors go!
clips will fit, but are a bit loose, if you want VS-VY Clips i have bag fulls, can put a set in an envelope.
Vlad there are some 3.5bar VS rails out there to, you just have to check the label on the reg.
Re: How to loose 200kgs?....
Posted: Mon Nov 16, 2015 10:32 pm
by vlad01
The1 wrote:Be good to see results and how the injectors go!
clips will fit, but are a bit loose, if you want VS-VY Clips i have bag fulls, can put a set in an envelope.
Vlad there are some 3.5bar VS rails out there to, you just have to check the label on the reg.
Was that late VS?