Re: GregsVN
Posted: Fri Nov 06, 2015 6:30 am
no I mean the option to use the alligator clip or the knock sensor, not both together.
- vz alloytec knock sensors.jpg (24.85 KiB) Viewed 3810 times
pcmhacking.net
Electronic Fuel Injection - Developement & Tuning
https://pcmhacking.net/forums/
Gregs Fleet
Page 28 of 86
Re: GregsVN
Posted: Fri Nov 06, 2015 10:53 am
I looked up the alloytec sensor wiring and it appears they don't need a separate power feed!
Re: GregsVN
Posted: Fri Nov 06, 2015 7:30 pm
nope. simply signal to the non inverting input of your op-amp 
Re: GregsVN
Posted: Fri Nov 06, 2015 7:33 pm
but your mic on other hand will be a bit different needing power for it, which is normally minimal.....so you will have to pull +12v down to something more bearable and then cap it to filter DC, and send that to the non inverting input of your op amp. a blocking diode should help on the knock sensor to stop power going back the other way
Re: GregsVN
Posted: Tue Nov 10, 2015 8:36 pm
on strike at present. wife has a prolapsed disc, so, off work, kid duty, nada going on in my car household. got my knock sensor and VP wiring book in the mail, other than that. zip.
Re: GregsVN
Posted: Tue Nov 10, 2015 8:39 pm
Thats bad news 
What program did you use to draw your wiring diagrams?
What program did you use to draw your wiring diagrams?
Re: GregsVN
Posted: Tue Nov 10, 2015 10:13 pm
Biggvl wrote:Thats bad news
What program did you use to draw your wiring diagrams?
MS Paint?
Re: GregsVN
Posted: Tue Nov 10, 2015 10:37 pm
I think i read Microsoft Visio in the post somewhere.
Re: GregsVN
Posted: Thu Nov 12, 2015 8:08 pm
vs ss is on the money. visio 2010. i love visio. still at home with the mrs, have seen the VN a couple of days this week and thats as close as i get. i am utterly stuffed, working from home, kids, wife, the lot has wrecked me hard core.
Re: GregsVN
Posted: Thu Nov 12, 2015 8:19 pm
Hey, what bits do you need for the door actuators? the whole guts and wiring?