Flex output ?

[VL400]

Factory uses two resistors switching them in at different temperatures, 3998 ohms at less than 50 degC and a 348 ohm above. This is to get a more accurate reading due to the non-linearity of the resistive sensor.

Being that you are using it for a transmission cooler fan just use the low value (standard values closest are 330 or 390 ohm) and calculate it from the known resistance vs temp table.

[Holden202T]

this might help you out, dad made this for me ages ago when I was trying to work out coolant sensor readings for using on a innovate data logger.

Engine Coolant Temperature.xls

[VL400]

Very handy, thanks for posting it up. I have used it heaps over the years when setting up temp monitoring with the logger.

[bf6379]

Was there ever a version of Flashtool released that defined the spare analog inputs as options for axis in flex output editor?

Thanks,

Brett.