Locked ls1 pcm need help

[TTVN]

pm sent about flash chips

[TTVN]

hey does anyone know if i can load an efilive .tun file straight onto the flash?????

i assume i can but theres no harm in asking

thanks guys

[Newbie]

Im not entirely sure if it will work as it is a encrytped file with additonal information for custom os etc tacked on. The .tun file is actually decrytped before it is uploaded to flash and encryted when it is saved again. I did it with a hpt file along time ago and it didnt work but it is worth a try, whats the worst can happen lol

[TTVN]

yeah thats what i reckon ill just wait till the flash chips and the sockets arrive and have a tinker

will be shit easy to test stuff then lol

thanks for that

[kojab]

hey does anyone know if i can load an efilive .tun file straight onto the flash?????

i assume i can but theres no harm in asking

thanks guys

No you can not load an efilive .tun file straight onto the flash its the wrong format. Efilive's .tun files are not 524,288 bytes (4 Mbits)

If you send me your .tun file I will convert it to a bin so you can flash that in.

Cheers
Dick

[TTVN]

hey does anyone know if i can load an efilive .tun file straight onto the flash?????

i assume i can but theres no harm in asking

thanks guys

No you can not load an efilive .tun file straight onto the flash its the wrong format. Efilive's .tun files are not 524,288 bytes (4 Mbits)

If you send me your .tun file I will convert it to a bin so you can flash that in.

Cheers
Dick

Thankyou heaps for that is much appreciated

cheers Rod

[TTVN]

thanks guys for all your help

flash chips arrived today so this arvo i flashed in the bin and poked the flash back in the pcm

Had to make up a couple of jumper wires as i broke off 2 of the pads the chip goes onto but they were easy ones to jump which is good

after a couple of soldering attempts i got good joints and it fired straight up no problem

I want to thank everyone for their help and info as its a learning curve lol

since i bought the elm327 cable im going to build a bench setup when i find a cheap damaged harness somewhere and socket a pcm so i can have a fiddle and try and get that seed key tool working and see if i can learn some more to try and be as helpful as u guys

cheers Rod

[jezzab]

also does anyone know where on the pcm the serial no is stored ??

You highlighted it in your post and the VIN number....

[TTVN]

thanks for that
i eventually worked that out lol
was previously lead to believe it was on a seperate chip which is why i asked
thanks for the reply

[TTVN]

also the sockets i ordered seem to have got lost between germany and here

not their fault i suppose but the wait is killing me lol