pcmhacking.net

i've only ever bought new (siemens deka's) and one set of second hand injectors off ebay.

can't find them new for under 350 bucks, thats the bosch no siemens ones came up on ebay.

for the LS1 injectors i think they are bosch. the dekas are 60 and 80lb

so what actually are these injectors rated at? some list them as 24 lb @ 3 bar, some at 26 lb @ 3 bar and I even see 27 and 28 lb @ 3 bar?


Looked at some listing on the net for bosch injectors and they mostly show up as 26 @ 3 bar.

I m confused all have the same color and PN too.


meanwhile.

now my shopping list escalates to new bonnet and new front left panel. That too was hit with a grinder and heaps of bog. so this got me checking the main body. Thankfully that all checks out repair free

Also the front right panel is a genuine holden replacement, but its a s2 panel which has no mounting hole for the rubber bumper blocks that the bonnet sits on. in s2 they changed them to an off stand bolt with a rubber pad on it.


So I had a stashed panel for my vacationer from few years ago which happen to be the correct replacement so last night I started stripping the hideous multi layer paint job., metal underneath was almost perfect!

i'd try and find manufacturers specs for the part number, hard to trust anything else on the net.

The 931's are rated for 3.5bar, but being ev6's will handle different pressure's fine, so you can run them at 3 bar and get 24lb or 3.5bar and get 26lb

the bosch page is here, but the rating will spec @ 3bar but there rated for 3.5bar

http://www.bosch.com.au/content/languag ... ectors.pdf

dont know why some label them as 28lb

omg, got s pdf from bosch. says those are 187cc at 3 bar, or 17lb via conversion. wtf?

but at 3.5 bar would this be 24 lb?

http://www.bosch.com.au/content/languag ... ectors.pdf

it's grams/min

oh haha so it is.

"whips out calculator"

24.735866 lb/h

so this would be around 26 lb at 3.5 bar?

should convert to 201.978 Grams/Min for 3.5bar or 26.718 lb