Page 56 of 153
Re: 265 Hemi to efi
Posted: Mon Feb 08, 2016 8:23 pm
by Dylan
That's the one to get. Check out dark wire they're an australian agent in WA. I got mine from there and my UV eraser. No problems and well priced.
Re: 265 Hemi to efi
Posted: Tue Feb 09, 2016 5:58 am
by heff0018
Thanks Dylan, I have been searching for dark wire and can't find anything.
Re: 265 Hemi to efi
Posted: Tue Feb 09, 2016 6:55 am
by Gareth
Re: 265 Hemi to efi
Posted: Tue Feb 09, 2016 7:07 am
by Dylan
To quick for me this hour of the night biggvl!
Anyway here's my effort
http://www.darkwire.com.au/html/gq-4x_u ... ammer.html
Re: 265 Hemi to efi
Posted: Tue Feb 09, 2016 7:46 am
by heff0018
Ha, what a different a space makes. I tried all types of searches using dark wire plus the product name, burner, electronics, WA all sorts but not darkwire.
Thanks, that is cheaper than buying from the manufacturer in $US and getting here.
Re: 265 Hemi to efi
Posted: Tue Feb 09, 2016 6:02 pm
by heff0018
Dylan wrote:Just a .atter of re burning not replacing it. I've had mine do it a couple times for unknown reasons.
Will flash tool connect? Switch to bank B and see if TP will connect.
Yes both flash tool and TP connects on bank B. Burner coming, and I have replaced the jumper so it's back on bank A. Is there any tricks to use the burner? I assume you plug in the NVRAM to the burner and copy over a good bin file. Cheers
Re: 265 Hemi to efi
Posted: Tue Feb 09, 2016 6:10 pm
by Dylan
Yes you burn a good bin. But it needs to be stacked. So stack a stock 12P bin 4 times with tuner pro and burn the stacked.bin file.
From memory you are running 12P 1.11?
Re: 265 Hemi to efi
Posted: Tue Feb 09, 2016 7:24 pm
by heff0018
Yes 12P v1.11, . Ok will have to check up on stacking. Cheers
Re: 265 Hemi to efi
Posted: Tue Feb 09, 2016 8:28 pm
by Jayme
the zip file for 12P will have pre stacked 128k bins. just burn any of them on, then put jumper on bank A and use flash tool to flash in your cal, then pull jumper for bank B then flash cal again.
Re: 265 Hemi to efi
Posted: Wed Feb 10, 2016 8:03 am
by heff0018
Jayme wrote:the zip file for 12P will have pre stacked 128k bins. just burn any of them on, then put jumper on bank A and use flash tool to flash in your cal, then pull jumper for bank B then flash cal again.
Yes found the stacked bin, thanks. So just to clarify, I don't have the jumper on when I burn the bin file.
Sorry, another dumb question. Do I first need to get the CAL from the ECM by connecting on Bank B and using flash tool to 'Get CAL'. Sounds obvious but at this stage of my knowledge I don't know where the corruption is i.e. NVRAM, Bin, CAL, what is actually corrupt.
Cheers