pcmhacking.net

NSFW wrote:

DavidBraley wrote:I see in the PCM Hammer log above that the recognized device is a OBDX Pro VT. Where can someone get one of these? Or is this the device that Pete is developing with another guy? [/url]

Yes it's that device, and "another guy" is who posted that log.

Ops! No disrespect Tazzi! I had no idea you are the other half of this thing. I speak for many when I say we are super excited about this interface. Looking forward to when it's available! I'm also happy to pay up front if it helps to bring this thing to market. I'm going to need two!

EDIT - zip file removed, new release published.

I'm not up on the C# side of things, where can I adjust the Timeout for the Allpro??

Had my first p59 succesful read today boys! on the autel j2534

Gampy wrote:I'm not up on the C# side of things, where can I adjust the Timeout for the Allpro??

Right now, the values from Device.GetVpwTimeoutMilliseconds() are used for all devices, so that's the place to experiment.

I think it was overly optimistic to assume that the same values would work for all of them, though. In a future release I'll make that virtual so that each device type can have its own timeout values. Might also add the ability to override timeout values in the .config file as well, so people can easily experiment and fine-tune.

NSFW wrote:Right now, the values from Device.GetVpwTimeoutMilliseconds() are used for all devices, so that's the place to experiment.

I think it was overly optimistic to assume that the same values would work for all of them, though. In a future release I'll make that virtual so that each device type can have its own timeout values. Might also add the ability to override timeout values in the .config file as well, so people can easily experiment and fine-tune.

Awesome, thank you.

For giggles I just disabled 4x on the AllPro and albeit slow it completed first time Zero retries!

Did a full read with PCM Hammer 009 on the MX+. It seemed to go faster and it definitely looked different in the debug log. Here are the log tabs from the full read.

NSFW wrote:Can someone please try writing to a 1mb Intel P59 using the .zip file that's attached to this post:
viewtopic.php?f=42&t=6593&p=96765#p96760

If that works I'll put out a new release that contains the fix.

Thanks!

Just test wrote with the MX+ on the PcmHammer010Preview1. Less than 2 minutes for a calibration update. Here are the logs.

Thanks for confirming!

I'm satisifed now so I'm going to release a new build.

Did another read on my actual truck. Worked. I should mention, i have had to put both pcms in recovery mode to do a full read with my j2534. I had a diablo trinity tune on this one but I unmarried it and reverted back to stock.

Now for some logs