pcmhacking.net

I've seen a race car similar to that but bigger flares, but steel and blended in, looked tidy as!

she sounds plenty lumpy! whats the cam specs ?

its only a baby LOL 272 advertised 224@0.050 biggest we could get for bananas .its lumpy cause its rich and not a lot of timing

that's alright man, least you haven't over cammed it like most people do and yeah I've tuned a 304 with 286 cam and bananas! a joke, the cam comes on and just after that it gets choked and I've seen the same cam in a 304 with 4 barrel TB and torque power dual plane, SO MUCH better to near on 7000rpm!

i just give my cam guys all my specs and he does his magic never sees me wrong LOL.i simmed it up last night on the pc looks like good torque from 1000 rpm to 4500 and max power at 5800-6000.should be a good combo for the street with the highstall and t700

yeah that sounds pretty good!

no more lumpy and its much quieter LOL.making the ecu read the map sensor helps run in at 92kpa god damn it least it survived 30 minutes of abuse
[youtube]http://www.youtube.com/watch?v=_rZ2-wda ... e=youtu.be[/youtube]

mates new ride i just helped prep for paint and reasemble

so last night i opened a can of worms LOL thought it was about time to rip the T350 down and check case condition before getting a crack welded in the bellhousing.omg its um full of clutch material and mud LOL its sat a number of years and has a rust hole or 2 in the pan LOL.also the clutches have seen some heat ill let the pics do the talking aye hehe.
mud gloreous mud LOL 1 clutch steel out of the first set of clutchs not good

looks fooked!

umm I don't think that's a clutch steel, I believe that's a wave plate and is supposed to be like that its for cushioning clutch apply!

I also believe the steel between clutch plates will have fingers all the way around them if its anything like the trimatic.

that one looks a lot like a reverse clutch, was it on the outside of the clutch drums against the case ?