Page 7 of 13
Re: Converting 202 to ABS Crank Trigger
Posted: Mon Jan 28, 2013 9:12 pm
by Holden202T
got it off the net, but it wasn't rusty when i got it, i should have painted it!! has been sitting in the shed for months, i'll be taking it to my mates workshop and using his sand blaster on it though don't you worry!
Re: Converting 202 to ABS Crank Trigger
Posted: Mon Jan 28, 2013 9:25 pm
by VX L67 Getrag
was there a part number or anything you typed into the NET to find it?
But yeah sand blaster & coat of paint might save it for a few more years!
Re: Converting 202 to ABS Crank Trigger
Posted: Mon Jan 28, 2013 10:06 pm
by Holden202T
i'm not sure if this was the exact seller but you get the idea
http://stores.ebay.com.au/trigger-wheel ... 34.c0.m322
Re: Converting 202 to ABS Crank Trigger
Posted: Tue Jan 29, 2013 5:17 pm
by VX L67 Getrag
WOW there's certainly a range of them!
Re: Converting 202 to ABS Crank Trigger
Posted: Tue Jan 29, 2013 5:43 pm
by Holden202T
yeah i found the one that was going to have the notches above my balancers diameter and went with that, wish it was solid like the picture showed though, would have been easier to put holes in!
Re: Converting 202 to ABS Crank Trigger
Posted: Sat Mar 02, 2013 4:41 pm
by Holden202T
well had some more progress on this, needed to finish mounting and locating the new trigger in the right spot relative to TDC etc and also needed to re-make the crank trigger bracket in the right spot so that has now all been done!
without precisely timing everything i'm thinking its going to be about 65 degrees reference angle !!
- new trigger mount 1.jpg (192.51 KiB) Viewed 6038 times
- new trigger mount 2.jpg (257.91 KiB) Viewed 6038 times
Another step closer to a dizzyless 6 coil 202
Re: Converting 202 to ABS Crank Trigger
Posted: Sat Mar 02, 2013 4:58 pm
by VX L67 Getrag
THAT IS FRIGGEN COOL! Nice work keep us updated!
Re: Converting 202 to ABS Crank Trigger
Posted: Sat Mar 02, 2013 5:12 pm
by Holden202T
will be once its running on it
Re: Converting 202 to ABS Crank Trigger
Posted: Sat Mar 02, 2013 5:23 pm
by VX L67 Getrag
I guess that all depends on how hard you push it to how COOL it keeps!!!
Re: Converting 202 to ABS Crank Trigger
Posted: Sat Mar 02, 2013 8:21 pm
by monaro308
Yeah thats looking good Holden202T
Hmmm a dissyless 308 red motor running 8 coils on the homemade Delco EFI