The1's Daily
Re: The1's Daily
Had missing and carrying on tracked it to dropping cam sensor, new genuine delphi, no good. Swapped for old Acdelco Mexico one and all good.
Re: The1's Daily
Already over 10,300 hz. Is that still the stock maf?
Re: The1's Daily
using the 90mm Silver Delphi metal one atm. Bench tested to 11,120hz so i should be good.
Got onto speedflow direct and bought the 5/16" and 3/8" push on fuel line fittings with 200 series hose and AN6 fittings, will fit up on weekend.
Got onto speedflow direct and bought the 5/16" and 3/8" push on fuel line fittings with 200 series hose and AN6 fittings, will fit up on weekend.
Re: The1's Daily
You are set. Do you plan to fit intercooler?
Last edited by L67PSI on Thu Jul 25, 2019 10:15 pm, edited 1 time in total.
Re: The1's Daily
nothing further atm, daily driver. Though i have another blower, so fiddle with that, see what else comes along. Ideally i want another daily driver so i can tinker with this more.
Thinking i might do some CAD and 3d Print some test U Bends, plenty of stuff to try.
Thinking i might do some CAD and 3d Print some test U Bends, plenty of stuff to try.
- vlad01
- Posts: 7841
- Joined: Mon Oct 08, 2012 6:41 pm
- cars: VP I S
VP I executive
VP II executive
VP II executive #2
VR II executive - Location: Kyneton, Vic
Re: The1's Daily
That's betterer.
I'm the director of VSH (Vlad's Spec Holden), because HSV were doing it ass about.
Re: The1's Daily
Those hoses & fittings look great.
- Holden202T
- Posts: 10328
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: The1's Daily
No matter what the question is, the answer is always more horsepower!
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Re: The1's Daily
yeh it's much better, the silver part of the piece just unscrews so taking them off is easy as no special clip tool required like factory fittings.