pcmhacking.net

what settings have you got, the below should work.

I never changed the one labelled coolant check I'll reflash today and see what happens 100% egr going up hill at 80kmh sucks lol

yeh factory ones at 5c so wont enable the coolant check.

ahh yeah that would do it!

Ok startup coolant check temp has sorted it she doesn't activate now thanks now to find some down low power it feels like torque reduction active at low revs then it just pulls like a train might be time to fit the wideband and force open loop for some fueling checks.especially after I gut the cat tomorrow lol

needs more timing down low ?

Vx flash usually has plenty of spark, check for retard

Could be nearly 500k km of timing chain stretch lol.its never been sharp or responsive my mates vy eco had a lot more down low and it was a high km taxi I'll shove the wideband up it and see where I'm at

Did you lower the pe cutin it's like 60% TPS from factory

Hi Mate,

I went to update the bin from 0.91 Enhanced to 1.00 to enable the WIDEBAND and MAP A5/B10 input support, it failed, and now I've lost comms to the NVRAM - I can't get hardware to detect anymore and no vehicle start even though it does crank.

Can I attempt to use OSE flash tool to upload the bin if I have no emulation hardware detected in Tuner Pro?

and if so, what options to I select, because VT V8 isn't listed in the drop-down box.


I tried my old cheap USB ALDL interface just to check, but still no dice.

Tried the Factory memcal, but I have no BCM, so not even a crank attempt.

If I didn't have "No hardware detected" I would just suspect I'd run out of fuel, but it won't start right after a unsuccessful bin write.

Any help would be appreciated.