VS Commodore Air bag light stuck on.

[ntmts]

Can confirm the vident unit connects to a VS commodore and allowed me to reset airbag light, and other modules . However you need to update it via the website prior to using as it did not work out of the box, it needed to be updated from the site. It comes with a USB adapter to update the memory card was fairly painless.

[S4wdust]

Hi all,

I am wondering if anyone has the extra files needed for the Vident i400 unit?

I am working with the support team at AZScanners.com.au, but so far no luck.

Thanks

[kodielees]

Hi,
I have a copy of the file I believe you are after that allows you to connect to the airbag section with the Vident module. Without it, you will continue getting an alarm message on the scanner. There is only one file that needs to be copied to the Scan/Holden subdirectory on the scanner SD card. Antus has contacted me about the file, so if you still need the file, feel free to reply.
Kindest Regards

[6910johnny]

Hey sorry to drag up an old thread.
I’m restoring a 1999 vs s3 maloo and I purchased a vident i400 and downloaded the Holden software. When I navigate to my car I cannot find the chassis and body modules to locate the srs. It only displays the engine and transmission modules.Am I missing these files or doesn’t this unit suit a 99 vs?
Thanks.

[The1]

it's probably looking for a VT model, try 98 or 97 even should show them up

[OZ38]

I found if you had a 1995 model VS Commodore the Vident i400 with Holden Software would not find much at all, as it only went back as far as a 97 model. I suspect it was the VT & not VS files.