Page 74 of 130

Re: 265 Hemi to efi

Posted: Wed Apr 26, 2017 8:01 pm
by heff0018
Just a question regarding my turbo exhaust manifold, is there any Advantage in running a narrow band sensor in addition to the wideband? The 14point7 Spartan controller I am running has the simulated narrowband output. Cheers

Re: 265 Hemi to efi

Posted: Thu Apr 27, 2017 8:06 am
by Holden202T
if the spartan does it ok then theres no real reason to change it other than if you wanted to move the wideband to another car.

Re: 265 Hemi to efi

Posted: Thu Apr 27, 2017 5:10 pm
by heff0018
Holden202T wrote:if the spartan does it ok then theres no real reason to change it other than if you wanted to move the wideband to another car.
Thanks Sam.

Re: 265 Hemi to efi

Posted: Mon May 22, 2017 4:31 pm
by heff0018
G'day all. Since installing my new head etc I have had problems with getting a smooth idle and tried all sorts of things from big timing and VE changes to swapping injectors and nothing worked. It was ok in drive under load but missing when in park. At the same time the brakes were running out of boost. I hadn't put the two together but the mechanic advised that the booster was stuffed and leaking vacuum. Great coincidence that it decided to do it at the same time that I change the head over.

Anyway the mechanic also checked the error codes and o the only error showing is MAP voltage high. Could this be linked to the vacuum leak or a problem with the MAP sensor. The check engine light has been glowing for as long as I can remember and its not as though it has just appeared since the vacuum problem. Cheers.

Re: 265 Hemi to efi

Posted: Mon May 22, 2017 4:49 pm
by festy
I was thinking vacuum leak half way through your first sentence ;)
The MAP voltage code is quite likely because of the vacuum leak. Check the MAP reading with the engine off, if it looks normal (~100 kPa), your MAP sensor is probably fine.

Re: 265 Hemi to efi

Posted: Mon May 22, 2017 5:05 pm
by heff0018
Thanks Festy

Re: 265 Hemi to efi

Posted: Wed May 24, 2017 7:29 am
by heff0018
If there was a problem with the MAP sensor itself could I replace it with a 3 bar unit and it still run ok in an unboosted setup. Thanks

Re: 265 Hemi to efi

Posted: Wed May 24, 2017 8:09 am
by festy
yes, as long as you changed the MAP flags in the bin to match the new sensor.
The downside is that you lose a lot of resolution.

Re: 265 Hemi to efi

Posted: Wed May 24, 2017 9:01 am
by Charlescrown
And make big changes to the tune because it will be running super lean because of the lower voltage going back to the ECU. I don't know if the resolution is a big problem because of interpolating between the cells.

Re: 265 Hemi to efi

Posted: Wed May 24, 2017 9:13 am
by Dylan
Never done this but by flagging 3 bar the scaling would be correct and no voltage issues?