Injector Flow Testing Data

[The1]

yep no doubt it will, though so far i haven't had demand for much over 42lb, though really it's only the high DC and RPM tests that will test it, low stuff and calibration type runs wont be an issue. I am toying with purchasing a used HP Switching Control unit and setting up automated runs with the psu and pcm.

[Holden202T]

you can also test only 4 injectors at a time to give you the capacity if needed!

[The1]

sorry dont follow? i can run any number.

[Helical]

Less injectors less flow required, won't max out the pump, I think that's what he's getting at.

[The1]

yeh thought so.

[The1]

Did some testing on brand new Bosch 1000cc injectors from Jayme

[Holden202T]

definitely looks like more of a misty spray than the deka's direct stream hehe

[vlad01]

nice action shots there.

Whats with the 0 dead times below 8V?

[The1]

no go, they need'd quiet a bit of time and even then very erratic. cranking usually doesn't go below 10v so shouldn't need it, but can put the default max in 3.89

[vlad01]

oh ok.

So basically they don't operate properly below that voltage.