pcmhacking.net

The1 wrote: ↑Wed Jan 15, 2025 3:29 pm ecu wont care lol rest of the car prob will! I will do VX once VY bin is confirmed, it should be somewhat quicker to port over hopefully

There's a VX comms flag, if set the bus data sent is VX, the flag is in the XDF and it works.

Chr0m3 wrote: ↑Thu Jan 16, 2025 7:45 pm

The1 wrote: ↑Wed Jan 15, 2025 3:29 pm ecu wont care lol rest of the car prob will! I will do VX once VY bin is confirmed, it should be somewhat quicker to port over hopefully

There's a VX comms flag, if set the bus data sent is VX, the flag is in the XDF and it works.

Cool I’ll give it a shot this weekend with some luck! Quite a few new tables which I’m excited to play with!

hsv08 wrote: ↑Thu Jan 16, 2025 7:47 pm

Chr0m3 wrote: ↑Thu Jan 16, 2025 7:45 pm

The1 wrote: ↑Wed Jan 15, 2025 3:29 pm ecu wont care lol rest of the car prob will! I will do VX once VY bin is confirmed, it should be somewhat quicker to port over hopefully

There's a VX comms flag, if set the bus data sent is VX, the flag is in the XDF and it works.

Cool I’ll give it a shot this weekend with some luck! Quite a few new tables which I’m excited to play with!

Even if you don't set the VX comms flag the car will run fine however dash will be lit up like a Christmas tree and temp gauge will not work.

I had forgotten about comms flag, nearly worth just running vy code and just having one version

The1 wrote: ↑Fri Jan 17, 2025 1:32 pm I had forgotten about comms flag, nearly worth just running vy code and just having one version

Yep, I'll be doing the same for spark cut release, no real reason to run VX entirely seperate and put all that work in twice.

Will make it easier not having to do vx xdf

Added vx comms back into the new xdf. I am noticing dtc29 egr position error in the logs though. But when log pintle position, feedback and position, nothings showing up. In engine diagnostics there is a few egr scalers like tps must be < cal to enable egr diagnostics at 7EDD. Might have to look and see if that overlaps any new code, and if not maybe lower that to zero and see. No big deal either way as there’s no check engine light anyway.

Yeh I've prob missed the malf code process, I'll check and release an update if needed.

updated VX VY L67 enhanced xdf, VX L67 Enhanced has been removed, you can use VY Version now, just enable comms flag in the xdf first. This will be the case also with new flash pcm version.