pcmhacking.net

Just a quick question,
once I have downloaded the .bin after a run to see the knock count logging, how do I reset it before taking another run and log?
Do I have to pull the ecm fuse or is there another way.

Its stored in the NVRAM iteslf and not RAM and is part of the calibration. Can either while emulating use the fill table with value in TP to clear it all or use the flashtool to write the cal back after editing the table in TP back to all zeros.

Thanks, after I posted I realised I could just update the table with zeros.
I should think for myself a bit more before posting.