Page 1 of 1
Un stacking bin's
Posted: Wed Jul 20, 2011 10:52 pm
by kelvin
I replaced the EPROM in my VN computer with a 28c256 EEPROM and I stacked the bins to fit giving a 32k file. Trouble is I had a computer failure and lost all my 16k bins, still have the 32's but the XDF won't accept the 32k file. How do I unstack my 32k files back to 16K.
Re: Un stacking bin's
Posted: Wed Jul 20, 2011 11:37 pm
by VL400
Can use the split function in TP, same tool as you used for stacking just select split in the corner.
Re: Un stacking bin's
Posted: Thu Jul 21, 2011 10:53 am
by kelvin
Hi, thanks for that. I took my 32k file and split it as you suggested and got a file which I called test1.bin, 16k in size. When I try to load it in Tunerpro it just says, no bin selected. Other 16k files load OK.
Re: Un stacking bin's
Posted: Thu Jul 21, 2011 2:58 pm
by antus
post your 16 or 32k files up here. Cant really tell whats wrong from your description.
Re: Un stacking bin's
Posted: Thu Jul 21, 2011 6:47 pm
by kelvin
Hi
My current bin is 'marobi10_32.bin', a 32k file, which I split into 'split1.bin', 16k. I thought perhaps I had the wrong XDF, but an earlier developement version that I still had in 16k, loads OK.
This all comes from my earlier computer falure. I'm using $5d.xdf at the moment, which looks nothing like the XDF I was using before. My previous XDF had much less options to change.
VN Commodore, Ecotec motor, BAAM computer.
Files included (I hope)
Re: Un stacking bin's
Posted: Thu Jul 21, 2011 6:57 pm
by VL400
Both bins are just all zeros
Re: Un stacking bin's
Posted: Thu Jul 21, 2011 7:19 pm
by kelvin
Well thanks for that. I went and looked at all my older 32k versions and some of them where infact all zeros, and I was playing with the most recent version which as I now know was empty. Don't know how that happened. Anyway, I can start again from a version not too far back, which is better than nothing.
I hope it's not something I stuffed up in splitting the file that cleared it.
Thanks for your help (again)