Page 4 of 4
Re: [Information] ALDL Basics
Posted: Tue Mar 31, 2015 12:30 pm
by Holden202T
no but it should work! I was almost going to use this to get a speedo on my trimatic equipped setup but found an alternative solution.
Re: [Information] ALDL Basics
Posted: Thu Apr 02, 2015 11:59 pm
by j_ds_au
matt304 wrote:I did not have the RS232 Echo box checked. Hard ware is not connecting.Saying cable is found. Bottom of screen is "Not Emulating" "Hardware not found" "DA:Not Connected. Connected to car again. Not working. Checkes DLC in car. Has power and earth. All looks ok
The Echo check box should be selected. "Saying cable is found" is good. Does it also find the cable when plugged into the car, with the ignition in the Off position? (That would also be good.) Finally, it may be helpful to know more about this cable.
Joe.
Re: [Information] ALDL Basics
Posted: Mon Apr 06, 2015 1:12 pm
by VL400
matt304 might have this sorted I suspect, was in 2012!
Re: [Information] ALDL Basics
Posted: Tue Apr 07, 2015 8:47 am
by j_ds_au
VL400 wrote:matt304 might have this sorted I suspect, was in 2012!
Oops! This thread had come back to life, but I forgot to check the date of that particular post. My bad.
Joe.
Re: [Information] ALDL Basics
Posted: Mon Dec 31, 2018 12:21 am
by j_ds_au
Hi Ryan,
In the opening post, it states :
"VR/VS ... This data bus allows for only one device to communicate at a time and connects all the major modules – BCM, ABS, SRS, ECM etc."
To avoid confusion, it would be helpful to note here that in the VS, the SRS has its own separate data bus.
Joe.