Page 60 of 69
Re: The1's Daily
Posted: Wed Apr 12, 2017 3:45 pm
by vlad01
Valves need more angles
Re: The1's Daily
Posted: Wed Apr 12, 2017 4:17 pm
by The1
as long as the boost holds
Re: The1's Daily
Posted: Thu Jul 11, 2019 8:50 pm
by The1
After a long time the L67 engine is finally built and in. Not without hassle cause of my own mistakes lol live and learn
Build ended up being.
Stock Bottom end
Mains oil holes drilled to largest factory size
Rear main plate oil passage enlarged a little
Bottom end balanced
Removed Balance shaft and plugged oil hole
New Pistons Federal Mogul H871CPA
Total Seal Rings CR6684 gap 0.023/24
All new bearings Clevite
SS Stock valves reseated
All ARP bolts
double row timing chain
Clive Cams Camshaft 112LSA 201 Duration @ 0.050 0.507 Lift with 1.95 Yella Terra Rockers
Everything ported as per previous
10psi stock looking pulley on blower
I have another blower that ill mess with later, fit up a modular pulley to it. I have a stack of photos here but prob nothing that hasn't been seen before.
Now to have fun tuning it!
- IMG_20190705_221804.png (510.51 KiB) Viewed 3816 times
Re: The1's Daily
Posted: Fri Jul 12, 2019 11:38 am
by Holden202T
all this thread is missing is a shed skid
Re: The1's Daily
Posted: Fri Jul 12, 2019 12:15 pm
by Gareth
Re: The1's Daily
Posted: Fri Jul 12, 2019 12:41 pm
by The1
haha, ok ill post up a few more.
Re: The1's Daily
Posted: Fri Jul 12, 2019 1:36 pm
by The1
Anyone come up replacement ideas for the factory push on fuel lines to the firewall from the fuel rail?
Ive gone through 2 hoses there all degraded and leak cause the rubber is failing, The supply line on the rail end on these L67's are larger, i found the VE Rail hose connector is the same size and isn't a compression fitting so i cut one off and made my own with double hose clamps and normal 10mm fuel hose. Holden dont stock or sell the fuel hoses new anymore, part number is 92078959. Only other thing im guessing i can do is replace the whole rail with aftermarket.
Re: The1's Daily
Posted: Fri Jul 12, 2019 4:37 pm
by Comcal76
I have mine setup like this with 10mm fuel hose.
Re: The1's Daily
Posted: Fri Jul 12, 2019 5:48 pm
by yoda69
What are the chances someone like Enzed or Pirtek could make one up.
Would have thought the actual connectors would be fairly standard.
Re: The1's Daily
Posted: Fri Jul 12, 2019 5:54 pm
by brindo
I thought EFI hardware have the quick connects, just need the hose then.