Suzuki Sierra 1 litre
Suzuki Sierra 1 litre
helping my mate out with doing his sierra up tried fitting a 1.3 and 5 speed to it but apparently the mounts and gearbox too long and different so were sticking with the original 1 litre and the 4 speed but were delcoing it using a barina tbi the 1.3 litre sierra electronic dissy commodore loom and n13 pulsar ignition module. now i was wondering on a very long shot if anyone may have a base tune maybe to start on they wouldnt mind throwing my way
- Attachments
-
- 2012-02-26 10.31.35.jpg (2 MiB) Viewed 3873 times
Re: Suzuki Sierra 1 litre
ok so now the blokes decided to take this conversion one step further and now were adding a Aisin AMR500 roots supercharger to the mix. now i was confident before just getting the engine to run on the delco but now im gonna need some pointers to set the tune up to run on boost
- Holden202T
- Posts: 10311
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: Suzuki Sierra 1 litre
well firstly you'll need to get either a 2 or 3 bar map sensor, then there is flags in the tune to set which sensor you have, once you have that done then you can look at tuning it!
No matter what the question is, the answer is always more horsepower!
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Re: Suzuki Sierra 1 litre
yea got the map sensor on the way and ive got all the flags under control but in terms of setting up the actual tune just to get it running on boost like the boost multipliers and ve tables how should i go about setting them up