VS-VY Enhanced Factory Bins

[Jayme]

id like your feedback on my formula for dec2 (M26 to M37) as it seems it negates the need for the macro. the goal is to get the value in the last cell of the maf table as close to but not exceeding 255.

[The1]

VT Supercharged Bins Are now done.

[The1]

have added the modded ADX file now as well.

[yoda69]

Jayme, yours is a much neater solution tham my Macro, might look at incoroporating this into mine, so I can remove one of my macro loops.

yoda69

[The1]

VX Supercharged is done now

[VX L67 Getrag]

Sent VY PCM & wiring harness today express so you should have for the weekend to play with!

[The1]

Nice

[The1]

Had a play on the bench today with VS V6 N/A, have added extended spark tables to high and low now, still same cylair as stock tables, but can atleast ramp spark up properly now, went for a drive to test and getting over 600cylair at redline! 9000hz MAF, slight increase, ramp it up a little more.

[trikky73]

looking good mate, have progressed very quickly on this
will be interesting to see this on an engine with plenty of mods - if I had only known about this when I built my motor

[The1]

depends on time, sometimes i get a whole day to work on this stuff then maybe not for a month later.

Has gone well with L67's ive tried it on, should have a dyno sheet to share from one in the near future.