pcmhacking.net

yes it should stay in open loop, no time delay from closed to open loop.

Can be done easily such as in this vid

[youtube]https://www.youtube.com/watch?v=RhlFeCC8H0g[/youtube]

Hi all, I'm about to tune my VS V6 with EnhancedMod and have got 2 Innovate Wide Band O2 sensors so I can monitor AFR/Lambda as I drive. The only question I have at the moment is. Can I use both pin A5 and B10 to tune with both widebands or does EnhancedMod require that I keep 1 narrowband operational.

you can use both A5 and B10 for widebands, just change the adx parameters to suit. If you check the flag single o2 sensor then just use the 1 narrowband on the drivers side.

The1 wrote:you can use both A5 and B10 for widebands, just change the adx parameters to suit. If you check the flag single o2 sensor then just use the 1 narrowband on the drivers side.

Is this the one you are referring to?

yes

Thanks, weather permitting I'll try to get to it this weekend.

Hi mate,

Just wondering if there are more dwell settings for the ignition system or what we see is all there is for ecotec/L67 tunes?

Thanks

Just wondering the same as the previous question. In the Enhanced code is there a way to adjust the dwell time? I have a LS coil driver from Ryan - VL400 and he was able to tweak it somehow, but I cant see anything defined for this.

pretty sure the DFI has alot to do with that, hence why Ryan's board used the output of the DFI to then control from there the spark.