I started off with the original chip BZPT in a vs V6 ute and i got the matching xdf and adx and i was able to data log and everything worked fine..
Then I put the nvram in with BSTJ and the ute would still run to test it out. I tryed a few different xdf and adx files but it wouldn't connect properly sometimes and when it did the emulation button wouldnt work and it said no hardware detected down the bottom of the screen?
Any suggestions?
not being able to emulate
- Holden202T
- Posts: 10311
- Joined: Sat Feb 28, 2009 9:05 pm
- Location: Tenambit, NSW
- Contact:
Re: not being able to emulate
are you using antus plugin for it or just tunerpros ?
No matter what the question is, the answer is always more horsepower!
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Just starting out? Have a read of the getting started guide
Basic tuning of a delco ECM with $12P thread
Advanced tuning of a delco ECM with $12P thread
Re: not being able to emulate
Using tunerpro RT with vl400's aldl cord and nvram.
Re: not being able to emulate
you cant emulate unless you use OSEplugin
https://pcmhacking.net/forums/viewtopic.php?f=3&t=590
and an RT enabled modified Bin file
https://pcmhacking.net/forums/viewtopic.php?f=27&t=613
https://pcmhacking.net/forums/viewtopic.php?f=3&t=590
and an RT enabled modified Bin file
https://pcmhacking.net/forums/viewtopic.php?f=27&t=613
-
- Posts: 19
- Joined: Fri Jul 06, 2012 2:42 pm
- cars: turbo v6 vp drag car
Supercharged v6 vx
Vl 308
Re: not being able to emulate
hey check that the nvram has a bin file on it like use the stack fuction we had heaps of issues with this. just plug in nvram only if car wont run ya need to stack the bin file.
Last edited by redbaron on Fri Sep 28, 2012 11:32 am, edited 1 time in total.
- antus
- Site Admin
- Posts: 8253
- Joined: Sat Feb 28, 2009 8:34 pm
- cars: TX Gemini 2L Twincam
TX Gemini SR20 18psi
Datsun 1200 Ute
Subaru Blitzen '06 EZ30 4th gen, 3.0R Spec B - Contact:
Re: not being able to emulate
Ok, just to keep it real, I need to throw in a correction. There is no splitting. There is only stacking, which is one possible way to get the bin file to the right location on the chip for it to work. If the car is in limp home mode, (CEL and fans on, and running like crap) then that might be your problem.
Have you read the FAQ? For lots of information and links to significant threads see here: http://pcmhacking.net/forums/viewtopic.php?f=7&t=1396
Re: not being able to emulate
Its all good got the plugin to work with the com port settings and got the matching definition file, everything runs and i can emulate
Thanks for the help!
Thanks for the help!