pcmhacking.net

long story short
i have just put on an A2A kit on my vx l67 supercharged and have brought a real time ecu (delco) and tunerpro rt software.
i have installed the programs and i am getting live feed from the ecu but i chose CXWK_modV2_EnhancedV1 NO VATS as a BIN file to upload and it will not upload and is now causing one of my relays to tick constantly??????????????
anyone now wot is going on?????
also looking for ls1 maf on l67 bin and a2a if anyone has done then?

please help

Did you purchase the setup from eBay? If so have you contacted the seller to help? You may not have the enhanced bin loaded, in which case you need to re-program the NVRAM using a programmer.

Thats way too short, have you loaded the NVram with the file first?

Also why are you using that file shouldn't you be using DDRJ?

Anything's possible with Delco, time & patience!

EDIT:VL Beat me to it!

did ya stack the bin files? on the chip 1st.

redbaron wrote:did ya stack the bin files? on the chip 1st.

no i didnt i am new to this program i am til getting the hang of it
is there a how to guy for dumbys

You dont need to stack bins when using a 128k bin on a DS1245Y - the bin fills the entire NVRAM, so burn at offset 0.