pcmhacking.net

Hi i am sorry if this has been covered before but i just finished putting and l67 into a torrie and i am running a getrag box and the ckum tune.
My question is apart from the vats and the checksum to make the tune a manual is all i have to do is tick or untick (either one i have not looked at the xdf yet) and thats it?
Cheers.

thats all I did..... VX l67 with a T5 box. tick manual flag, then drive.

for manual getrag you'll need to tick both manual flags.

yeah we didnt even hook up the speed sensor at all lol.... didnt have any stalling problems at lights either like hte 808's do.

Just another question regarding the tune.
Does the tune have to be edited where the auto normaly would not reach (eg below stall speed)
Thanks.

Honestly there's no easy answer or tweak, all the idle airflow function/areas have changed so there's a bit of tweaking to do in my experience to get them to idle right in EVERY Instance!

if your in the position that you want to tune an area where the stall never see's its generally best to go with the flow, ie. If the curve has a certain arc to it, continue with that, just keep things smooth and flowing and it should be ok!

Ok thanks I was just asking cause it a factory s/c tune with a manual and when going slow under load I was not sure if it was mapped in this area.
cheers.